From Hackerspace ACKspace
|
|
| (8 intermediate revisions by the same user not shown) |
| Line 1: |
Line 1: |
| − | <noinclude>{{Featured}}</noinclude>{{Project
| + | #REDIRECT [[ESP8266]] |
| − | |State=Active
| |
| − | |Members=Prodigity, Da Syntax, xopr
| |
| − | |Description=Playing around with cheap wifi modules
| |
| − | }}== synopsis ==
| |
| − | To make the ESP8266 more accessible to everyone I have created a "programmer" which allows for easy firmware uploading and communication with the module.
| |
| − | | |
| − | [[Image:Runprogrun.JPG|335px|thumb|Behold, the ESP^2 (esp egg salad programmer).]] | |
| − | | |
| − | == Revision 1.1 ==
| |
| − | [[User:Xopr|xopr]] Modified the ESP^2 a bit:
| |
| − | * Added three wires (VCC, GND and GPIO2) for Dallas temperature sensor debugging (wire ends are insulated)
| |
| − | * Added pullup resistor was added so GPIO0 can be used after the device has been booted
| |
| − | * Added resistor to the 5V ESP^2 TX signal (should be two diodes I guess, the resistor divider didn't work)
| |
| − | | |
| − | == Todo ==
| |
| − | Find a way to program the ESP-12 (2mm pitch) modules without much hassle (note that it needs a 10k resistor between GPIO15 and GND) to boot correctly
| |
Latest revision as of 10:36, 20 November 2021
