Difference between revisions of "ESP-2"
(removed from featured list until the next project update) |
(set project picture) |
||
| Line 3: | Line 3: | ||
|Members=Prodigity | |Members=Prodigity | ||
|Description=Playing around with cheap wifi modules | |Description=Playing around with cheap wifi modules | ||
| − | }}== synopsis == | + | |Picture=Runprogrun.JPG |
| + | }} | ||
| + | == synopsis == | ||
To make the ESP8266 more accessible to everyone [[User:Prodigity|Prodigity]] has created a "programmer" which allows for easy firmware uploading and communication with the [[ESP]]-01 module. | To make the ESP8266 more accessible to everyone [[User:Prodigity|Prodigity]] has created a "programmer" which allows for easy firmware uploading and communication with the [[ESP]]-01 module. | ||
| − | |||
| − | |||
== Revision 1.1 == | == Revision 1.1 == | ||
Revision as of 22:30, 3 November 2015
| Project: ESP-2 | |
|---|---|
| Featured: | |
| State | Completed |
| Members | Prodigity |
| GitHub | No GitHub project defined. Add your project here. |
| Description | Playing around with cheap wifi modules |
| Picture | |
| |
synopsis
To make the ESP8266 more accessible to everyone Prodigity has created a "programmer" which allows for easy firmware uploading and communication with the ESP-01 module.
Revision 1.1
xopr Modified the ESP^2 a bit:
- Added three wires (VCC, GND and GPIO2) for Dallas temperature sensor debugging (wire ends are insulated)
- Added pullup resistor was added so GPIO0 can be used after the device has been booted
- Added resistor to the 5V ESP^2 TX signal (should be two diodes I guess, the resistor divider didn't work)
Todo
Find a way to program the ESP-12 (2mm pitch) modules without much hassle (note that it needs a 10k resistor between GPIO15 and GND) to boot correctly
